Entries by admin

Online kennis vergroten

Medewerkers van PM vergroten hun kennis en expertise op het gebied van Slijpen met deze online cursus. De cursus is specifiek afgestemd op de wensen van PM. Innogrind and STODT bring education in grinding online. Last week we started at a bearing manufacturer in The Netherlands. Training is also available in English and German language. Aerospace EN4179 […]

PCD, CBN and carbide tool grinding

The challenge During production of PCD and CBN tools heat is a challenge to avoid, or at least to minimize. Van Frankenhuyzen in Lexmond (The Netherlands) is a world leading producer of these PCD and CBN mills. The challenge given to us by Van Frankenhuyzen was, process stability and no chipping for 24/7 production. The […]

Uitnodiging Slijpacademie

STODT en Innogrind nodigen u uit voor een interactief en informerende slijpbijeenkomst om zo gezamenlijke kennis te deling en het vakmanschap te vergroten in de slijpindustrie. Tijdens de bijeenkomst komen actuele onderwerpen aan de orde zoals: Slijpthema’s Ontwikkeling smart industry Introductie slijpacademie Inventarisatie (opleidings)wensen Programma: 15.00 uur – Inloop 15.15 uur – Welkom en introductie […]

Quality Controlled Shot-Peening for HSLA materials

Shot-Peening is used to generate surface-near compressive residual stresses in final shape parts, usually to improve their fatigue properties. The success of the process can be checked in different ways. XRD and Hole-Drilling determine quantitative stress depth profiles in specific locations. Barkhausen noise measurements evaluate a near-surface zone in real-time and can cover large areas […]

Root cause analysis

Root cause analysis results in stable and safer process at lower cost The challenge When our client (a parts manufacturer for food processing machinery) switched from stainless steel 416 to 17-4PH of 45Hrc in their profile surface grinding operations, thermal damage started occurring directly after the material change. The manufacturer turned to INNOGRIND to analyse […]

Cooling additives in grinding

Barkhausen Noise Analysis – benchmark analysis of coolant additives in the grinding process  The challenge Our customer wanted to know whether it was possible to optimize a coolant fluid in a grinding process using Barkhausen Noise Analysis. The two main issues which they wanted evaluated were grinding burn and reducing oil mist to a minimum. […]

KLM Maintenance & Engeneering

Detection of thermal damage on vital parts for the aerospace industry The challenge High Strength Low Alloy (HSLA) steel is widely used in the aerospace industry for the manufacture of vital parts. Hard-to-detect thermal damage to such parts – incurred during the manufacturing process – can have major and impacting consequences. KLM was looking to […]

Innogrind present at the EMO Hannover

Exhibitors travel to EMO Hannover from all over the world and from all sectors of metalworking technology. With a share of foreign exhibitors running at approximately 60%, EMO Hannover is the world’s most international metalworking trade fair. As the leading fair of its kind, it serves as a networking hub epitomizing the highest level of […]

Top 5 root causes of grinding burn

Grinding burn or thermal damage is a common cause of machine or engine component failure. When grinding heat is not quickly detected and removed by a suitable cooling solution, it can have a big impact on the service life of the product. In order to detect grinding burn in an early stage, it is important […]

Persconferentie 7 mei – Amsterdam

EMO Hannover brengt in september 2019 het volledige spectrum van metaalbewerkingstechniek naar Hannover. Op dinsdag 7 mei organiseert Hannover Consultancy B.V. een persconferentie voor Nederlandse vakjournalisten in The Dylan Amsterdam. Jos van Langh van Innogrind zal gastspreker zijn!